Weir’s SPM QEM 3000 Frac Pump enters Canadian market

QEM_Launch_Event_1-16_-_PHOTO_(high-res)Fort Worth, Texas-based Weir Oil & Gas (Weir), one of the world’s largest suppliers of pressure pumping equipment to the upstream market, has partnered with Calgary, Alberta-based Canyon Services Group (Canyon) to take its innovative SPM® QEM 3000 frac pump to the field.

Arriving at a critical time when service companies are looking for technology that operates more efficiently for less, this pump is projected to reduce total cost of ownership by 17 per cent. This new technology was validated through extensive in-house testing at Weir’s state-of-the-art research and development (R&D) facility, which resulted in the successful completion of a 13 million-cycle endurance test.

Canyon’s upcoming field run will operate for at least 4,000 hours and include deployment of the SPM QEM 3000 to a production site for fracking operations in the Duvernay and Montney formations in the Western Canada Sedimentary Basin. Specifically, the pump was retrofitted onto a hydraulic fracturing power system currently in-use at a live, Canyon-operated well site by R4 Equipment Renewal.

“At Weir, we work in close partnership with our customers and during the development of the SPM QEM 3000, input from partners like Canyon was crucial. This customer-led approach means we now have a pump that is not only the most durable on the market but also addresses demand for more efficient, continuous-duty equipment with a lower cost of ownership,” said David Paradis, president of pressure pumping at Weir Oil & Gas. “The traditional frac pump development process typically tests up to 1 million cycles at full-rod load, so the fact that our R&D team has completed a 13 million-cycle endurance test proves the SPM QEM 3000 is second to none in terms of durability, cost-efficiency, long-term performance and life span.”

“Required operating hours, increased rod loads, longer laterals, increased proppant volumes, and more completion stages have translated into increasing demand for continuous-duty equipment,” said Todd Thue, chief operating officer at Canyon Services Group. “Through collaborations with partners like Weir, we are able to keep up with our evolving industry and find solutions to these challenges, improving our efficiency in the field and ultimately reducing our operating costs.”

Engineered to perform at an increased number of stages and longer horizontals, the SPM QEM 3000 pump addresses significant industry challenges and delivers a solution to reduce the total cost of ownership.

Design features and benefits include:

  • Utilization of the largest frac pump bearing on the market to increase component life and better align it with maintenance intervals of the engine and transmission;
  • Structural rigidity in the forged frame provides more stability to increase pump life and lower maintenance;
  • Dual-line system provides the right amount of pressure and flow for each pump component and provides excellent lube flow in cold starts;
  • Onboard filtration reduces lubricant contamination to optimize pump performance;
  • Gearbox capabilities to withstanding continuous-duty operations at a 275,000-pound rod load with minimal maintenance; and,
  • Patented geometry of SPM® Duralast™ Fluid End lowers cross bore stresses by 30 percent or more, doubling the life compared to conventional fluid ends.

For more information about the SPM QEM 3000 frac pump, visit or, call Weir at 817-246-2461, or email


Leave a Reply

Your email address will not be published. Required fields are marked *